Point is a concept in SI that allows you to add a designation of the action needed, such as tuning or programming required, or "functionality" to an input or output of a product.
You can create a list of Points in the Control Panel and assign them to products in the Project Editor. The points data of the product will be stored at the Project level and can be displayed on schematic pages in Visio.
Within a project, open the product for editing and click the I/Os tab, then the Points tab.
When you click Add, the following dialog will open, where you will select a point and a port (I/O).
You can modify the default labor hours and change the default labor item if desired.
If you have chosen to associate a labor accessory with your points, once you save the product, the labor item will be added as an accessory to the product.
If more than one point uses the same labor accessory, the labor hours will be appended to the same labor item vs. adding a new one.
In the example below, two points were added to the product, one with one hour assigned to it and the other with half an hour assigned to it, both assigned to the labor item "Global Vision Ltd : Programming." Only one labor item was added, and the Labor Hours field is set to 1.5 hours.
Notice that the Labor Hours field is locked for editing. This is so that if a point is removed from the item, the hours will decrease and remain accurate.